Appliances and ventilation
Standard Kitchen Appliance Dimensions and Cabinet Openings
Kitchen cabinets are laid out around the appliances. Each appliance needs an opening of a particular width, height and depth, plus clearance for doors, ventilation and connections. A layout drawn with generic sizes can fail when the actual models arrive.
This guide lists the typical dimensions of common US kitchen appliances. They are useful for early planning. Before cabinets are ordered, download the installation guide or specification sheet for each chosen model and use its stated cutout and clearance dimensions.
Typical appliance sizes
| Appliance | Typical width | Typical height | Typical depth |
|---|---|---|---|
| Freestanding or slide-in range | 30 inches (also 20, 24, 36 and 48) | 36 inches to the cooktop | 25 to 29 inches including door and handle |
| Standard-depth refrigerator | 30 to 36 inches | 66 to 70 inches | 30 to 36 inches including doors |
| Counter-depth refrigerator | 30 to 36 inches | 68 to 72 inches | Box about 24 to 25 inches, 27 to 30 inches with doors and handles |
| Built-in refrigerator | 30 to 48 inches | About 84 inches | About 24 to 25 inches, flush with cabinets |
| Dishwasher | 24 inches (compact 18 inches) | Adjustable, about 33.5 to 35 inches | About 24 inches |
| Over-the-range microwave | 30 inches | 16 to 18 inches | 15 to 18 inches |
| Single wall oven | 24, 27 or 30 inches | 27 to 29 inches | About 24 inches |
| Cooktop | 30 or 36 inches | 3 to 5 inches below the counter | About 21 inches |
The stated width is nominal. A 30-inch range is slightly under 30 inches wide so that it fits a 30-inch opening, and a 36-inch refrigerator is usually about 35.75 inches wide.
Ranges and cooktops
A freestanding range has finished sides and a backguard with the controls. A slide-in range has controls at the front and a cooktop that overlaps or meets the countertop at the sides, which gives a built-in look. Both fit a 30-inch opening in most cases, but slide-in models can require the countertop to continue behind the range, so check the specification before the countertop is templated.
Ranges need an anti-tip bracket fastened to the floor or wall, which is supplied with the appliance. Gas ranges need a gas shutoff and a 120-volt outlet in the locations shown in the installation guide. Electric and induction ranges need a 240-volt circuit, usually 40 or 50 amps. The instructions also specify minimum clearances to side walls and to cabinets or other combustible materials above the cooking surface.
Refrigerators
Refrigerator depth has the largest effect on a layout. A standard-depth model extends 6 inches or more beyond the countertop edge. A counter-depth model has a box about as deep as the cabinets, with only the doors standing proud so they can swing open. Counter-depth models have less capacity for the same width and usually cost more.
- Leave the air clearance stated by the manufacturer. About 1 inch at the top and back and 1/8 to 1/2 inch at the sides is common for freestanding models.
- Check the door swing. A door next to a wall needs about 2 to 4 inches of filler or space on the hinge side to open far enough for the drawers to pull out.
- French door and side-by-side models have narrower doors that need less aisle space than a single wide door.
- An ice maker or water dispenser needs a water supply line with a shutoff valve.
- Measure the path into the house. Doorways, hallways and stair turns must be wide enough for delivery.
The opening is commonly built 36 inches wide and about 70 to 72 inches high for a freestanding refrigerator, with a 24-inch-deep cabinet above and tall panels at the sides.
Dishwashers
A standard dishwasher fits an opening 24 inches wide, about 24 inches deep and 34 to 34.5 inches high under the countertop. The leveling legs adjust over a small range. New flooring installed only in front of an existing dishwasher can trap it under the countertop, so the floor height in the opening should match the kitchen floor or be planned to allow removal.
The dishwasher is normally placed beside the sink, within about 36 inches, so the drain and supply lines can connect under the sink. Its door projects about 24 to 27 inches when open, so check that it does not block a corner cabinet, the trash pull-out or the main aisle. Dishwashers need a hot water supply, a drain connection with a high loop or air gap as the local plumbing code requires, and a dedicated electrical circuit in most installations.
Microwaves and wall ovens
An over-the-range microwave mounts to the wall and to the cabinet above, and needs a 30-inch-wide space and an outlet inside the upper cabinet. Manufacturers commonly call for the top of the unit to be at least 66 inches above the floor, and the range's required clearance above the cooktop also applies. Shorter users may find hot dishes hard to lift down from that height.
Wall ovens are installed in a tall oven cabinet with a cutout matched to the model. Cutout sizes are not interchangeable between brands, which matters when replacing an old oven in an existing cabinet. A double oven needs a cutout about 50 to 53 inches high. Wall ovens need a 240-volt circuit sized according to the installation instructions.
Panel-ready appliances
A panel-ready appliance is made to accept a custom cabinet panel on its door so it blends with the surrounding cabinets. Dishwashers and built-in or column refrigerators are the most common examples.
The manufacturer specifies the panel dimensions, thickness, maximum weight and handle requirements. The cabinet maker builds the panels from those specifications, so the appliance model must be chosen before the cabinets are ordered. Panel-ready refrigerators are built-in units that require an exact opening and, in many cases, anchoring to the wall or adjacent cabinets.
Common appliance planning mistakes
- Ordering cabinets from generic appliance sizes before models are chosen
- Forgetting that refrigerator depth includes doors and handles
- A refrigerator door that hits a wall or an island and cannot open fully
- Flooring that locks the dishwasher under the countertop
- No outlet, gas shutoff or water valve in the location the instructions require
- Replacing a wall oven without checking the existing cutout size
- Overlooking the delivery path through doors and stairs
- Ignoring required clearances between the cooking surface and cabinets above
Frequently asked questions
What is the standard width of a kitchen range?
Thirty inches is the standard width in US kitchens. Ranges are also made in 20 and 24 inch widths for small kitchens and in 36 and 48 inch widths for larger ones.
What does counter-depth refrigerator mean?
It means the refrigerator's cabinet box is about 24 to 25 inches deep, roughly the same as base cabinets, so only the doors and handles extend past the countertop. Total depth with doors is usually 27 to 30 inches.
How much space does a dishwasher need?
A standard dishwasher needs an opening 24 inches wide, about 24 inches deep and at least 34 inches high under the countertop. Compact models fit an 18-inch-wide opening. Check the installation guide for the exact figures.
How wide should the refrigerator opening be?
For a nominal 36-inch freestanding refrigerator, an opening of 36 inches is typical, since the unit itself is slightly narrower. Follow the manufacturer's stated clearances, and allow extra space on the hinge side if the refrigerator sits next to a wall.
Are panel-ready appliances more expensive?
Generally yes. The appliances themselves tend to be priced higher, and the custom panels, handles and installation are an additional cost. They are chosen for appearance, not for performance.